Drop wire clamp with S hook is designed to support both ends of 1 and 2-pair reinforced service drops and to connect a triplex overhead entrance cable to a devices or buildings.Widely used both indoor installation and outdoor installation.Provided with a serrated shim to increase hold on drop wire. Used to support one and two pair telephone drop wire at span clamps, drive hooks, optic fiber cable in FTTH solution and various drop attachments.These drop wire clamps are made from stainless steel or galvanized steel.This Drop Wire Clamp is used to support 1,2 and 6 pair telephone drop wire at span clamps, drive hooks, and various drop attachments. The clamp have a serrated shim for increased hold on drop wire.Usually 1 pair – 2 pair wire clamps are designed to support both ends of an aerial service drop using one or two pairs drop wires,6 pairs wire clamps are designed to support both ends of an aerial service drop using six pairs fiber reinforced drop wires,and we have the style of 2 knots,3knots and 4knots in all.
Drop Wire Clamps with shall hold, a suitable length of drop wire until sufficient load are applied to break the drop wire or to a maximum load of 500 pounds, the clamps consist of shell, shim, wedge and bail, which are all made of high quality stainless steel processed by punching technology. The installing method for the drop wire clamps is very easy and no request any other tools. Just put the suitable size flat fiber optic cable in the shell, put the raised embossing shim against cable, then insert wedge and tighten it firstly, at last attach this clamp on drop wire hook or bracket.
All our drop wire clamp are all inspected by a series tests,the test are for overhead line deployment,and include tensile strength test, salt spray corrosion test and etc. And our products can be sold to over 40 countries all over the world,and enjoy good reputation in the world electrical market
